| If omitted: | Password will not be added to on-the-fly commands |
| Relevance conditions: | onthefly= "outofband" or "inband" |
Clogin (command login) parameter specifies the password that should be added to the on-the-fly commands. On-the-fly commands can be sent without prior login using Login (L) command . Instead, the password can be added to each command individually (see out-of-band (UDP) programming ). On-the-fly Password (OP) setting on the DS must be programmed to 1 (enabled) to make the DS check the password. Password specified by the clogin parameter must match the one defined through the Password (PW) setting of the DS.
When clogin parameter is omitted all on-the-fly commands are sent without password. This parameter is only relevant when on-the-fly commands are not disabled.