Controlling VSPDL Operation

Top  Previous  Next

 

Use the following commands to start the VSPDL:

 

#/etc/rc.d/init.d/vspm start (must report [OK] if started successfully).

 

#/etc/rc.d/init.d/vspd start.

 

As explained in how VSP works, the VSPLD configuration is stored in the configuration file vspd.conf. After the file is edited and changes saved you must "update" driver configuration by using the following command:

 

/etc/rc.d/init.d/vspd reloadconf

 

This will make the VSPDL re-read the file and start using new configuration. Configuration can be updated even when the VSPDL is working i.e. some VSPs are opened and in use.