SB100x Board Dimensions
SB100x supplementary boards ("SB") have the same height as IB100x interface boards ("IB"). An "SB" is narrower — its maximum width is limited to 67mm. The limit is due to the IC1000 interboard cable connector protruding from the side of the "IB." The "SB" does not have to have a maximum width — it can be as short as permitted by the design.
|
W |
Max. |
67.0 |
Board width |
|
H |
Aver. |
85.0 |
Board height |
|
T |
Aver. |
1.6 |
Board thickness |
|
g |
Min. |
5.0 |
No-component zone height |
|
d |
Aver. |
3.0 |
Mounting hole diameter |
|
m1 |
Aver. |
3.0 |
Distance to the board mounting hole |
|
m2 |
Aver. |
2.5 |
Distance to the board mounting hole |
|
c |
Max. |
19.0 |
Header & interboard cable connector height |
|
G |
Aver. |
18.5 |
Gap between the IB100x and SB100x boards* |
* This is the standard gap; it will "happen" automatically when the boards are used inside the DS10xx housing.
Dimensions are for reference only. Tibbo assumes no responsibility for any errors in this manual, and does not make any commitment to update the information contained herein.