Ordering Info and Specifications

Use the following model numbers to order the IB1005 and SB1005 boards. Normally, you will want to order both boards "in parallel":

IB1005

The IB1005 board and LB1001 LED board mounted on the IB1005 and connected to the latter with the LC1000 cable. Also included is the TB1005 test board.

SB1005

The SB1005 supplementary board. Order this board "in parallel" with the IB1005.

Note: The IB1005 and SB1005 plug into each other. No soldering is required to interconnect them.


Hardware Specifications

Opto-isolated inputs

Eight channels:

  • Channels 1~4: 2V~15V input range, can be used to connect card readers
  • Channels 5~8: 5V~50V input range

Relays

Six relays, 30VDC/16A or 250VAC/15A

Serial port lines

RS232 mode: RX, TX

RS485 mode: RX+/–, TX+/–

Baudrate

Up to 460,800bps

Operating temperature

–30°C to +80°C

Operating relative humidity

10-90%

Dimensions

76x85mm

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.


Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our customer.


Ordering Info and Specifications

Hardware Specifications