TEV-LB1
The TEV-LB1 carries a 128x96, 4-bit RITDISPLAY RGS13128096 OLED panel. This panel is based on a SOLOMON SSD1329 controller.
Interconnection Between the EM1000 and the Panel
|
Pin #* |
EM1000 I/O line |
Panel |
|
5 |
GPIO48 |
--- |
|
6 |
GPIO47 |
--- |
|
7 |
GPIO46 |
--- |
|
8 |
GPIO39/P4.7 |
D7 |
|
9 |
GPIO38/P4.6 |
D6 |
|
10 |
GPIO37/P4.5 |
D5 |
|
11 |
GPIO36/P4.4 |
D4 |
|
12 |
GPIO35/P4.3 |
D3 |
|
13 |
GPIO34/P4.2 |
D2 |
|
14 |
GPIO33/P4.1 |
D1 |
|
15 |
GPIO32/P4.0 |
D0 |
|
16 |
GPIO44 |
RST |
|
17 |
GPIO43 |
D/C |
|
18 |
GPIO42 |
R/W |
|
19 |
GPIO41 |
E |
|
20 |
GPIO40 |
CS |
* Pin number on the TEV-LB1 connector.
Required Tibbo BASIC/C Initialization Code
This section assumes that you are familiar with Tibbo BASIC/C and Tibbo IDE (TIDE).
For correct panel operation, click Project-> Settings, and select the EM1000 or EM1000G platform. Additionally, click Customize to open a Customize Project dialog. In the dialog, double-click the Display Panel Type line and choose Solomon SSD1329 (Ritdisplay RGS13128096).
The following initialization code should also be added to your project:
lcd.iomapping="44,43,42,41,40,4" 'RST,DC,WR,RD,CS,data_bus
'(W is marked "R/W" on the schematic diagram, RD is marked "E")
io.num=PL_IO_NUM_40
io.enabled=YES
io.num=PL_IO_NUM_41
io.enabled=YES
io.num=PL_IO_NUM_42
io.enabled=YES
io.num=PL_IO_NUM_43
io.enabled=YES
io.num=PL_IO_NUM_44
io.enabled=YES
lcd.width=128
lcd.height=96
lcd.rotated=NO
lcd.inverted=NO
lcd.enabled=YES