Ordering Info and Specifications

Use the following model numbers to order the IB1004 and SB1004 boards. Normally, you will want to order both boards "in parallel":

IB1004	The IB1004 board and LB1001 LED board mounted on the IB1004 and connected to the latter with the LC1000 cable. Also included is the TB1004 test board.
SB1004	The SB1004 supplementary board. Order this board "in parallel" with the IB1004.

Note: The IB1004 and SB1004 plug into each other. No soldering is required to interconnect them.

Hardware Specifications

A/D channels	Eight channels, 24-bit resolution
D/A channels	Four channels, voltage and current output, 14-bit resolution
Relays	Two relays, 24V/1A
Serial port lines	RS232 mode: RX, TX RS485 mode: RX+/–, TX+/–
Baudrate	Up to 460,800bps
Operating temperature	–30°C to +80°C
Operating relative humidity	10-90%
Dimensions	76x85mm

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this manual, and does not make any commitment to update the information contained herein.

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our customer.