Power, Reset, and Mode Selection Lines

The EM200 should be powered from a stabilized DC power supply with nominal output voltage of 5V (±5% tolerance). The current consumption of the EM200 is approximately 220mA (in 100BaseT mode). Providing an adequate power supply is very important — a poorly built circuit may affect EM200 operation. We recommend that you use a switching power supply circuit. One (but not the only) example of such circuit is shown below.

A proper external reset is a must! The reset pulse should be an active HIGH. We strongly advise against using low-cost RC networks and other unreliable methods of generating a reset pulse. The reset should be applied for as long as the power supply voltage is less than 4.6V. We recommend using a dedicated reset IC with brownout detection, such as the MAX810. The reset pulse length should be no less than 50ms, counting from the moment the power supply voltage exceeds 4.6V.

If the EM200 is used to serve as a communications coprocessor in a larger system that has its own CPU, it is also OK to control the RST line of the EM200 through a general-purpose I/O pin of the "host" microcontroller. The I/O pins of many microcontrollers default to HIGH after power-up, meaning that a proper reset will be applied to the EM200 when the host device is switched on. All the host microcontroller has to do is release the EM200 from reset at an appropriate time by switching the state of the I/O line to LOW.

The function of the MD line is described in Setup (MD) Button (Line).


Power Supply Circuit

Many power supply circuits will work well. The one below is used by Tibbo. The circuit can handle input voltages in the 9V~30V range.

A diagram of a power supply circuit.

Notes:


A tip note icon.Ideally, you should use an oscilloscope to see what sort of "square wave" the power supply generates, both at low and high input voltages, as well as light and heavy loads. There are no recipes here — just try and see what works for your circuit.


Power, Reset, and Mode Selection Lines

Power Supply Circuit