Ordering Info and Specifications
This is a legacy product. The following is provided as it was documented originally, albeit with some corrections and changes for clarity and style.
The EM203A has several versions available. Device numbering scheme is as follows:
Examples of Valid Model Numbers
|
Model number |
Description |
|
EM203A-00 |
Connector configured to mate with the EM203A jack/magnetics module, the module will be supplied with the "serial-to-Ethernet" firmware |
|
EM203A-D-00 |
Connectors configured to mate with the host PCB, the module will be supplied with the "serial-to-Ethernet" firmware |
|
EM203A-DP-00 |
Connectors configured to mate with the host PCB, the module will be supplied with the TiOS firmware |
Ordering the EM203A and RJ203A Module Combination
The EM203A can also be ordered in combination with the RJ203A module. To receive these two modules pre-assembled together, please specify "RJ203A+EM203A" on your order if you wish to receive the EM203A with the "serial-to-Ethernet" firmware preloaded, or "RJ203A+EM203A-P" if you wish to receive the EM203A with the TiOS firmware preloaded.
Specifications
|
Ethernet interface |
10/100BaseT Ethernet, magnetics not built-in |
|
Serial ports |
1 port, CMOS-level |
|
UART capabilities |
Baudrates up to 115'200bps; none/even/odd/mark/space parity and 7/8 bits/character; full-duplex UART mode with optional flow control* and half-duplex UART mode with automatic direction control*; RX, TX, RTS*, CTS*, DTR*, and DSR* lines. |
|
LEDs |
x4 : red and green status LEDs*, yellow and green Ethernet status LEDs |
|
Max. load current for each I/O line |
10mA |
|
Supported network protocols* |
UDP*, TCP*, ICMP (ping)*, and DHCP*. |
|
Nominal power supply voltage (VCC pin) |
DC 5.0V, +/- 5% |
|
Device reset |
Proper reset must be provided externally, RST pin has active HIGH polarity |
|
Max. operating current |
220mA |
|
Operating temperature |
-20 to +70 degrees C |
|
Operating relative humidity |
10-90% |
|
Mechanical dimensions (excl. leads) |
30.1x18.1x12.5mm |
|
Packaging |
EM203A devices: tray, 30 modules/tray EM203A+RJ203A module combination: tube, 10 modules/tube |
* Implemented in (supported through) firmware.
All specifications are for reference only. Tibbo assumes no responsibility for any errors which may appear in this manual, and does not make any commitment to update the information contained herein.