Ordering Info and Specifications

The WA2000 device is available in two configurations:

WA2000U – U.FL connector for an external antenna.
WA2000C – chip antenna onboard.

Specifications

Compatibility	EM510, EM2000, EM2001, TPP2(G2), TPP3(G2) – support for both Wi-Fi and BLE; EM1000, EM1001, EM1206, EM1202, DS1101/2 – support for Wi-Fi only
Wireless interfaces	802.11a/b/g/n + BLE4.2
Host interface type	SPI
Nominal power supply voltage (VCC pin)	DC 3.3V, +/- 5%
Operating current (VCC pin)	Post-reset, before boot: ~70mA; Fully functional, no data transmission: ~120mA; During the data transmission: ~200mA; Short current consumption bursts up to 500mA.
Operating temperature range	-40 to +85 degrees C
Operating relative humidity	10-90%
Mechanical dimensions (excl. leads)	42.0 x 20.0 x 6.0 mm
Packaging	Tray, 30 modules/tray.

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.