Ordering Info and Specifications
The EM510 "MiniMo" (R) device is only available in a single configuration and can be ordered as "EM510".
Hardware specifications
Ethernet interface |
10/100BaseT Ethernet, Auto-MDIX, magnetics not built-in |
Serial ports |
1 port, CMOS-level. |
UART capabilities |
Baudrates up to 460'800bps; none/even/odd/mark/space parity and 7/8 bits/character (7 bits/character and "none" parity cannot be used together). |
Number of I/O lines |
10 I/O lines: 8 GPIO lines plus TX and RX lines of the serial port; GPIO lines are combined into an 8-bit port; 2 GPIO lines can be used as interrupt lines; I/O lines are NOT 5V-tolerant. |
Max. load current for each I/O line |
10mA |
Flash memory |
512 KBytes, 224KBytes are available to store a compiled Tibbo BASIC/C application; this memory cannot be used as a flash disk. |
EEPROM memory |
2048 bytes, 2016 bytes are available to store application data. The typical write endurance is around 1'000'000 write cycles per 8-byte EEPROM sector. See Prolonging and Estimating EEPROM life. |
Nominal power supply voltage (VCC pin) |
DC 3.3V, +/- 5% |
Operating current (VCC pin) |
110mA |
Operating temperature |
-40 to +85 degrees C |
Operating relative humidity |
10-90% |
Mechanical dimensions (excl. leads) |
18.5x16.0x6.5mm |
Pin diameter |
0.4mm |
Packaging |
Tray, 30 modules/tray |
All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.