EM500EV-MB0

EM500EV-MB0 Annotated

The EM500EV-MB0 board incorporates a socket for inserting the EM500 or EM510 IoT module.

note_warning-wt

It is physically possible to plug the EM500 (EM510) module into the EM500EV-MB0 incorrectly. Doing so may irreparably damage the modules.

Only plug the EM500 (EM510) as shown on the photo above.

The EM500EV-MB0 board also features the following:

  • A power jack and a switching regulator with 3.3V output. This 3.3V power is supplied to the EM500 (EM510) and is also provided on the interface board connector (see below).

  • An MD button, which is connected to the MD input of the EM500 (EM510).

  • Green and red status LEDs.

  • A two-row interface board connector.

Interface board (IB) connector

Pin #

Function

1

Vcc output (3.3V)

2

GND

3

RX (1)

4

TX (1)

5

GPIO0/P0.0/INT0 (1)

6

GPIO1/P0.1/INT1 (1)

7

GPIO2/P0.2 (1)

8

GPIO3/P0.3 (1)

9

GPIO4/P0.4 (1)

10

GPIO5/P0.5 (1)

11

GPIO6/P0.6 (1)

12

GPIO7/P0.7 (1)

13

MD (1)

14

RST (1)

15

GND

16

VIN (12V)

(1) Directly connected to the corresponding pin of the EM500 (EM510).