Ordering Info and Specifications
The device numbering scheme for the NB1010 is as follows:
All NB1010 boards are equipped with 1,024KB of flash memory.
NB1010 devices without the "G", "C", or "GC" options are not being offered by Tibbo. If you want to purchase an Ethernet-only board (without any wireless options), then order the NB1000 instead.
Examples of Valid Model Numbers
|
Model number |
Description |
|
NB1010GC |
The board with Wi-Fi and GPRS interfaces |
|
NB1010C |
The board with GPRS interface |
External Antenna
The Wi-Fi interface works better when equipped with an antenna. In the absence of a Wi-Fi antenna, the Wi-Fi interface still works (relying on a small "chip" antenna on the GA1000), but the operating range is reduced. The GPRS interface can't work without the antenna at all. Therefore, consider purchasing external antennas as required by your application.
Hardware Specifications
|
Ethernet interface |
10/100BaseT Ethernet, Auto-MDIX |
|
Wi-Fi interface |
Optional, uses the GA1000 add-on module |
|
GPRS interface |
Optional, uses the TELIT GC864 GPRS module (www.telit.com) |
|
Serial ports |
Four ports, CMOS-level |
|
UART capabilities |
Baudrates up to 921,600bps; none/even/odd/mark/space parity and 7/8 bits/character |
|
Max. load current for each I/O line |
10mA |
|
Square wave generator |
6Hz ~ 22.1184MHz, connected to buzzer |
|
Real-time counter (RTC) |
40 bit, increments at 128Hz |
|
RTC backup power source |
Supercapacitor, supports RTC for approximately six days |
|
Clock frequency |
11.0592MHz with PLL off 88.4736MHz with PLL on |
|
Flash memory |
1,024KB, entire memory minus 64KB is available to store Tibbo BASIC/C application and data. Typical write endurance is 100,000 write cycles per 256-byte sector. See the warning in Flash Memory and EEPROM. |
|
EEPROM memory |
2,048 bytes, 2,020 bytes available to store application data. Typical write endurance is around 1'000'000 write cycles per 16-byte EEPROM sector. See Prolonging and Estimating EEPROM life. |
|
Power supply voltage |
10~18VDC |
|
Operating temperature |
–30°C to +80°C |
|
Operating relative humidity |
10-90% |
|
Board dimensions |
76x85mm |
|
Pin diameter |
0.64mm |
All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this manual, and does not make any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our customer.