TEV-LB1

Top  Previous  Next

The TEV-LB1 board carries a 128x96, 4-bit RITDISPLAY RGS13128096 OLED panel. This panel is based on a SOLOMON SSD1329 controller.

Related datasheets, as well as the schematic diagram for the TEV-LB1 board can be found on Tibbo website.

Interconnection between the EM1000 and the panel

Pin #(1)

EM1000 I/O line

Panel

5

GPIO48

---

6

GPIO47

---

7

GPIO46

---

8

GPIO39/P4.7

D7

9

GPIO38/P4.6

D6

10

GPIO37/P4.5

D5

11

GPIO36/P4.4

D4

12

GPIO35/P4.3

D3

13

GPIO34/P4.2

D2

14

GPIO33/P4.1

D1

15

GPIO32/P4.0

D0

16

GPIO44

RST

17

GPIO43

D/C

18

GPIO42

R/W

19

GPIO41

E

20

GPIO40

CS

(1) Pin number on the TEV-LB1 connector.

Required initialization code in Tibbo BASIC/C application

This section assumes that you are familiar with Tibbo BASIC/C and TIDE software. These are documented in the "TIDE and Tibbo BASIC Manual".

For correct panel operation, click Project-> Settings, and select "EM1000" or "EM1000G" platform. Additionally, click Customize to open a Customize Platform dialog. In the dialog, double-click the Display Panel Type line and choose "Solomon SSD1329 (Ritdisplay RGS13128096)".

The following initialization code should also be added to your project:

 

 

lcd.iomapping="44,43,42,41,40,4" 'RST,DC,WR,RD,CS,data_bus

'(W is marked "R/W" on the schematic diagram, RD is marked "E")

   

io.num=PL_IO_NUM_40

io.enabled=YES

   

io.num=PL_IO_NUM_41

io.enabled=YES

 

io.num=PL_IO_NUM_42

io.enabled=YES

 

io.num=PL_IO_NUM_43

io.enabled=YES

 

io.num=PL_IO_NUM_44

io.enabled=YES

 

lcd.width=128

lcd.height=96

lcd.rotated=NO

lcd.inverted=NO

lcd.enabled=YES