Power Jack, Terminals and Power Regulator

Top  Previous  Next

Power jack of the NB1010 accepts "small" power connectors with 3.5mm diameter. Use 12VDC/1A APR-P0008 (APR-P0009, or APR-P0010) power adaptor supplied by Tibbo or similar adaptor. On the power jack, the ground is "on the outside", as shown on the figure below.

Another way to connect power is through the power terminals located next to the power jack. Ground and "+" terminal positions are shown on the NB1010 drawing. Acceptable supply power range is 10-18VDC (12VDC nominal).

 

pjack_12_18v

 

The NB1010 carries an onboard regulator that provides stabilized 3.3V power to the NB1010 itself and to an IB100x interface board, connected to the NB1010 via the IC1000 interboard cable.

Note, that the IC1000 interboard cable also has lines that carry "raw" input power (Vin lines). The IB100x board you are using may have its own power supply.