|Top Previous Next|
There is a simple serial port that supports both RS232 and RS485 modes. The port operates through two signal terminals. In the RS232 mode, these are RX and TX, in the RS485 mode -- RX/TX+ and RX/TX-. There is no provision for flow control (RTS and CTS lines are not present), or RS422 interface.
The serial port can be used, for instance, to connect to another IB100x board. In the RS232 mode, the serial port can also be used to update the firmware of the EM1000 module located on the NB10x0 board.
Serial port lines
Serial port lines are on terminal block 1:
Serial port control
*GPIO line configured as input (default state)
Do not forget to configure the TX, MODE, and DIR lines as outputs. A pull-down resistor on the MODE line ensures that the system boots up with the RS232 port selected.