Ordering Info and Specifications

Top  Previous  Next

Use the following model numbers to order the IB1004 and SB1004 boards. Normally, you will want to order both boards "in parallel":

IB1004

The IB1004 board and LB1001 LED board mounted on the IB1004 and connected to the latter with the LC1000 cable. Also included is the TB1004 test board.

SB1004

The SB1004 supplementary board. Order this board "in parallel" with the IB1004.

 

Note: the IB1004 and SB1004 plug into each other. No soldering is required to interconnect them.

Hardware specifications

A/D channels

8 channels, 24-bit resolution

D/A channels

4 channels, voltage and current output, 14-bit resolution

Relays

2 relays, 24V/1A

Serial port lines

RS232 mode: RX, TX

RS485 mode: RX+/-, TX+/-

Baudrate

Up to 460800bps

Operating temperature

-30 to +80 degrees C

Operating relative humidity

10-90%

Dimensions

76x85mm

 

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

 

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.