Ordering Info and Specifications

Top  Previous  Next

The GA1000 device is available in two configurations: GA1000 and GA1000L. Use the GA1000 device with all compatible products except the LTPP3 board. For this board, order the GA1000L.

A set consisting of the EM1000 and GA1000 modules can be ordered using the "EM1000G" ordering code (see Specifications and Ordering Info for the EM1000). Likewise, a set consisting of the EM2000 and GA1000 modules can be ordered as "EM2000G".

Specifications

 

Compatibility

GA1000: DS1101, DS1102, EM500, EM1000, EM1001, EM1206, EM2000, EM2001, TPP2, TPP2(G2), TPP3, TPP3(G2)

GA1000L: LTPP3

Wireless interface

802.11b/g

Host interface type

SPI

Nominal power supply voltage (VCC pin)

DC 3.3V, +/- 5%

Operating current (VCC pin)

Post-reset, before boot: ~65mA;

Fully functional, no data transmission: ~200mA;

During data transmission: ~280mA.

Operating temperature range

-20 to +70 degrees C

Operating relative humidity

10-90%

Mechanical dimensions (excl. leads)

42x19x6.7mm

Packaging

Tray, 30 modules/tray.

 

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

 

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.