Ordering Info and Specifications

Top  Previous  Next

The EM510 "MiniMo" (R) device is only available in a single configuration and can be ordered as "EM510".

Hardware specifications

Ethernet interface

10/100BaseT Ethernet, Auto-MDIX, magnetics not built-in

Serial ports

1 port, CMOS-level.

UART capabilities

Baudrates up to 460'800bps; none/even/odd/mark/space parity and 7/8 bits/character (7 bits/character and "none" parity cannot be used together).

Number of I/O lines

10 I/O lines: 8 GPIO lines plus TX and RX lines of the serial port;

GPIO lines are combined into an 8-bit port;

2 GPIO lines can be used as interrupt lines;

I/O lines are NOT 5V-tolerant.

Max. load current for each I/O line

10mA

Flash memory

512 KBytes, 224KBytes are available to store a compiled Tibbo BASIC/C application;

this memory cannot be used as a flash disk.

EEPROM memory

2048 bytes, 2016 bytes are available to store application data.

The typical write endurance is around 1'000'000 write cycles per 8-byte EEPROM sector. See Prolonging and Estimating EEPROM life.

Nominal power supply voltage (VCC pin)

DC 3.3V, +/- 5%

Operating current (VCC pin)

110mA

Operating temperature

-40 to +85 degrees C

Operating relative humidity

10-90%

Mechanical dimensions (excl. leads)

18.5x16.0x6.5mm

Pin diameter

0.4mm

Packaging

Tray, 30 modules/tray

 

 

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

 

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.