Power, Reset, and Mode Selection Lines

Top  Previous  Next

The EM510 should be powered from a stabilized DC power supply with a nominal output voltage of 3.3V (+/- 5% tolerance). The module's current consumption is approximately 110mA. Providing an adequate power supply is very important — a poorly built circuit may affect the EM510's operation. We recommend that you use a switching power regulator. One example of such a circuit is shown below.

External reset is optional — the EM510 generates a reliable power-on/brown-out reset on its own. If the EM510 is to serve as a communications co-processor in a larger system that has its own CPU (microcontroller) it is also OK to control the RST line through a general-purpose I/O pin of this CPU. Reset pulses for the EM510 can then be generated programmatically, by setting the I/O pin of the CPU to LOW and then to HIGH.

The function of the MD line is described in Setup Button (MD line).

Power supply circuit

Many power supply circuits will work well. The one below is being used by Tibbo. This circuit can handle input voltages in the 9-24V range.

 

em_power_33v

Notes:

U1 (AP1501-33) is a popular power IC manufactured by Anachip (now Diodes Incorporated, www.diodes.com)

C1 and C2 capacitors: Do not use SMD capacitors -- use regular through-hole aluminum capacitors. This really helps reduce the noise produced by the power supply.

This is an analog circuit, so layout matters. Apply reasonable "good layout" effort.