EM500EV-MB0

Top  Previous  Next

EM500EV-MB0 Annotated

 

The EM500EV-MB0 board incorporates a socket for inserting the EM500 or EM510 IoT module.

 

note_warning-wt

It is physically possible to plug the EM500 (EM510) module into the EM500EV-MB0 incorrectly. Doing so may irreparably damage the modules.

Only plug the EM500 (EM510) as shown on the photo above.

 

The EM500EV-MB0 board also features the following:

A power jack and a switching regulator with 3.3V output. This 3.3V power is supplied to the EM500 (EM510) and is also provided on the interface board connector (see below).

An MD button, which is connected to the MD input of the EM500 (EM510).

Green and red status LEDs.

A two-row interface board connector.

Interface board (IB) connector

Pin #

Function

1

Vcc output (3.3V)

2

GND

3

RX (1)

4

TX (1)

5

GPIO0/P0.0/INT0 (1)

6

GPIO1/P0.1/INT1 (1)

7

GPIO2/P0.2 (1)

8

GPIO3/P0.3 (1)

9

GPIO4/P0.4 (1)

10

GPIO5/P0.5 (1)

11

GPIO6/P0.6 (1)

12

GPIO7/P0.7 (1)

13

MD (1)

14

RST (1)

15

GND

16

VIN (12V)

 

(1) Directly connected to the corresponding pin of the EM500 (EM510).