Power, Reset, PLL Control, and Mode Selection

Top  Previous  Next

Power

The EM2000 should be powered from a stabilized DC power supply with the nominal output voltage of 3.3V (+/- 5% tolerance). This power should be applied to the pin #60. "-A" modification of the EM2000 has the second VCC pin -- #72. To prevent "current loops", use either pin (but not both pins) to supply the power to the device.

The current consumption of the EM2000 is approximately 100mA (PLL on, 100BaseT mode). This does not include the power consumption of the wireless add-on module, such as the GA1000. This Wi-Fi add-on significantly contributes to the power consumed by the EM2000. Therefore, providing an adequate power supply is very important — a poorly built circuit may affect EM2000 operation. We recommend that you use a switching power supply.

For correct device operation, the VCCB line should not be left unconnected. You may connect this line to the backup battery, or main 3.3V power (see Real-time Counter).

 

Reset

Proper external reset is not required. The EM2000 has a reliable power-on reset circuit with brown-out detection. Optionally, you can connect a reset button or some other reset-generating circuit to the RST pin of the EM2000. This will allow you to generate external resets. The RST line has active LOW polarity. If you are not using the RST pin you can leave it unconnected.

 

PLL control

The EM2000 can run at three clock frequencies (speeds):

Full speed: 120MHz (default post-reset speed)

Medium speed: 43Mhz

Low speed: 16MHz

 

The clock speed can be changed programmatically, via the system (sys.) object. For more information see "TIDE and Tibbo BASIC Manual".

 

Mode selection

The function of the MD line is described in Appendix 2: Setup Button (MD line).