Power Arrangement

Top  Previous  Next

The EM1202EV-RS and "-TM" devices have "12V"-to-3.3V switching regulator onboard. The power is supplied through the power jack. The power jack of the EM1202EV accepts "small" power connectors with 3.5mm diameter. Use APR-P0011, APR-P0012, or APR-P0013 power adaptor supplied by Tibbo or similar adaptor with 12V nominal output voltage. Adaptor current rating should be at least 500mA. On the power jack, the ground is "on the outside", as shown on the figure below.

 

pjack2

 

Stabilized 3.3V power used by the EM1202EV-RS and "-TM" is also available on pin 12 of the TTL interface connector. This can be used to provide power to an attached serial device.

The EM1202EV-TS board does not have "12V"-to-3.3V regulator at all. 3.3V power required for board operation must be supplied by the external device through pin 12 of the TTL interface connector.