General-purpose I/O Lines

Top  Previous  Next

The EM1001 has 54 general-purpose I/O lines (GPIO0 - GPIO53). All lines are 3.3V, CMOS, 5V-tolerant lines. The maximum load current for each I/O line is 10mA. 49 of these lines are always available. Remaining 5 lines are located on the wireless add-on connector and can be used if no wireless add-on module is installed.

40 of the I/O lines are combined into five 8-bit ports.

The simplified structure for one I/O line is shown on the circuit diagram below. Each line has an independent output buffer control. When the EM1001 powers up, all I/O lines have their output buffers tri-stated (in other words, all I/O lines are configured as inputs). You need to explicitly enable the output buffer of a certain I/O line if you want this line to work as an output.

Many I/O lines of the EM1001 also serve as inputs or outputs of special function modules, such as serial ports. The majority of those lines need to be correctly configured as inputs or outputs -- this won't happen automatically. Several lines -- such as TX and RX lines of the serial port when in the UART mode -- are configured as outputs and inputs automatically when the serial port (or some other hardware block) is enabled. For details see "Platform-dependent Programming Information inside the EM1000 platform documentation ("TIDE and Tibbo BASIC Manual").

Each I/O line has a weak pull-up resistor that prevents the line from floating when the output buffer is tri-stated.

EM1000_IO_pin_circuit

 

I/O line control is described in detail in the documentation for the I/O (io.) object found inside the "TIDE and Tibbo BASIC Manual".