Notes:
Standard EM1000 devices do not have an SPI port connector and the "landing" PCB area for the connector is left empty (cross-section A).
Compatible slave SPI modules (such as the GA1000 Wi-Fi module) can optionally be soldered into the SPI connector pads (cross-section B).
Option "-A" EM1000 devices feature a 10-pin SPI port pin header (cross-section C). The pins on this header are identical to all other pins of the EM1000 and, like the latter, face the host PCB. This way the SPI port of the EM1000 can be connected to some other circuitry on the host PCB. For example, instead of piggy-backing the GA1000 onto the EM1000, you can opt to place it on the host PCB. The EM1000 "-A" module is then required to facilitate a connection between the EM1000 and the GA1000.
Finally, option "-T" devices have a female SPI port connector soldered in. Slave SPI modules, such as the GA1000, can be plugged into this female connector. EM1000 modules of "-T" variety are intended for convenient slave module testing and are not recommended for use in production devices.
L |
Max. |
38.4 |
Module length |
W |
Max. |
28.4 |
Module width |
H |
Max. |
5.5 |
Module height |
H' |
Max. |
11.0 |
Module height with the GA1000 module installed on top of the EM1000 module |
h |
Max. |
4 |
Additional height added by the supercapacitor ("-S" option devices only) |
I |
Min. |
6.0 |
Lead length |
p |
Aver. |
2.54 |
Pin pitch |
Dimensions are for reference only. Tibbo assumes no responsibility for any errors which may appear in this Manual, and does not make any commitment to update the information contained herein.