Ordering Info and Specifications

Top  Previous  Next

The DS1202 device is only available in a single configuration and can be order as "DS1202".

 

Hardware specifications

Ethernet interface

10/100BaseT Ethernet, Auto-MDIX

Serial ports

One RS232 port (DB9M) with 3.5 serial channels (four inputs and three outputs)

UART capabilities

Baudrates up to 921'600bps; none/even/odd/mark/space parity and 7/8 bits/character.

Clock frequency

11.0592MHz with PLL off

88.4736MHz with PLL on

Flash memory

1024KBytes, entire memory minus 64KB is available to store Tibbo BASIC/C application and data.

Typical write endurance is 100'000 write cycles per 256-byte sector. See the warning in Flash and EEPROM Memory.

EEPROM memory

2048 bytes, 2020 bytes available to store application data.

Typical write endurance is around 1'000'000 write cycles per 16-byte EEPROM sector. See Prolonging and Estimating EEPROM life.

Supply voltage range

DC 10-24V (12V nominal)

Operating temperature

-5 to +70 degrees C

Operating relative humidity

10-90%

Mechanical dimensions

60x47x30mm

Carton dimensions

125x95x52mm

Gross weight

110g

 

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

 

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.