Ordering Info and Specifications

Top  Previous  Next

Device numbering scheme is as follows:

 

DS110x numbering system

Visit our online store for the up-to-date list of accessories offered with DS110x devices.

 

Examples of valid model numbers

 

Model number

Description

DS1101GD

DS1101 device with the Wi-Fi add-on and OLED display

DS1102P

DS1102 device with the power-over-Ethernet module

 

Hardware specifications

 

DS1100

DS1101

DS1102

Device color

ds1100_small

ds1101_small

ds1102_small

Ethernet interface

10/100BaseT Ethernet, Auto-MDIX, magnetics not built-in

Serial port

RS232 port on DB9M connector

RS232 port on DB9M connector

RS232/422/485 port on DB9M conn.

No of serial port channels

1 channel

3.5 channels

3 channels (RS232), 1 ch.(RS422/485)

Serial port lines

TX, RX, RTS, CTS, DTR, DSR

TX, RX, RTS, CTS, DTR, DSR, DCD

TX, RX, RTS, CTS, DTR, DSR (RS232)

TX, RX, RTS, CTS (RS422)

TX, RX half-duplex (RS485)

Maximum baudrate

Up to 115200bps

Up to 921600bps

Flow and direction control

Optional RTS/CTS flow control

Opt. RTS/CTS flow control (232/422)

Direction control (RS485)

Parity modes

None/even/odd/mark/space parity

Bits/character

7/8 bits/character

Power input/output on DB9

"12V" power input on pin 9 of DB9

"12V" power input and output on pin 9 of DB9 (software-controllable)

not provided

Flash memory

512KB for firmware and application storage. No flash disk functionality.

1024KB for firmware, application and data (flash disk).

Typical write endurance is 100'000 write cycles per 256-byte sector. See the warning in Flash and EEPROM Memory.

EEPROM

208 bytes, 180 bytes are available to store application data.*

2048 bytes, 2020 bytes are available to store application data.*

LEDs

Red and green status LEDs

Yellow Ethernet link LED

Red and green status LEDs

Yellow Ethernet link LED

Five blue LEDs (can be used for Wi-Fi signal strength indication)

Wi-Fi

no

optional 802.11b/g interface (GA1000)**

Display

no

optional 96x32 monochrome OLED

PoE

optional

optional*

Buzzer

no

yes

Processor

T2000

T1000

Operating frequency and PLL

80Mhz, no PLL

88MHz, software-controlled PLL

Firmware upgrades

Through the serial port or network (including cold upgrade firmware uploads through the network).

Through the serial port or network (no cold upgrades through the network).

Supply voltage

12VDC nominal (min. 9V, max. 18V)

Operating temperature range

-5 ~ 70 degrees C

Operating relative humidity

10 ~ 90%

 

Mechanical dimensions

90x48x25mm

 

Carton dimensions

137x99x70mm

 

* Typical write endurance is around 1'000'000 write cycles per EEPROM sector. See Prolonging and Estimating EEPROM life.

** Wi-Fi and PoE options are mutually exclusive and cannot be installed together

 

All specifications are subject to change without notice and are for reference only. Tibbo assumes no responsibility for any errors in this Manual, and does not make any commitment to update the information contained herein.

 

Think the above table should contain additional data? Do not just assume that you know the answer — talk to Tibbo! Remember that the ultimate responsibility for all decisions you make regarding the use and the mode of use of Tibbo products lies with you, our Customer.