#51, M1S: CAN Bus
|Top Previous Next|
Function: CAN bus transceiver with isolated power
Form factor: M1S
Category: Input/output module
Special needs: [CAN]
Power requirements: 5V/60mA (keep in mind that externally attached CAN devices may additionally consume up to 200mA)
See also: ---
This Tibbit features an isolated power supply that can provide up to 200mA of power to attached CAN devices.
This Tibbit is only supported on Linux-based boards, such as the LTPP3 board.
There are two LEDs: one red and one green connected to the TX and RX lines correspondingly.